Installation is easy. You need a flat, vertical area with a place for UniStrut to be attached.
The cabinets have feet or ledges that are provided for easy installation; when installing the cabinet - only use the feet or ledges provided to secure to the UniStrut. Any modifications made to the cabinet for mounting purposes (i.e. drilling holes through the box to mount, or hanging directly without the feet) will void the warranty and change the UL rating.
FOR CABINETS WITH LEDGES: To maintain the warranty and UL rating - use these ledges for hanging instead of modifying the box.
Mounting ledge detail on CommsSafe box.
These mounting ledges are on the top and bottom of the CommsSafe box. Holes are equally spaced for support and structure.
Use the predrilled holes on the hanging ledge to secure the box to the Unistrut. DO NOT drill new holes into the hanging ledge.
FOR CABINETS WITH FEET: When the cabinet first arrives to the site, the feet will be facing inwards (see below image). To properly mount the cabinet without voiding the warranty - remove the feet, set them to the proper braced position, then fully secure them again. (see pictures below) This process should not require you to modify the cabinet enclosure in any way.
Feet arrive in a braced position. Remove the screws and reorient as shown below.
The feet are now set up to hang the box and will allow easy access to the mounting gear.
To ensure maximum safety and efficacy - mount all UniStrut so it is level, and then hang the cabinet on the UniStrut.